Bigfoot calibration specifically 35SB3 (From TapaTalk Forum)

LANDING PAGE › Forums › COMMON RV COMPONENTS & ISSUES › FRAME, SUSPENSION COMPONENTS, LEVELING SYSTEMS, HITCHES, WEIGHTS & WEIGHING, and TIRES › LEVELING SYSTEMS › HYDRALIC LEVELING SYSTEMS › Bigfoot calibration specifically 35SB3 (From TapaTalk Forum)

  • Creator
    Topic
  • 06/22/2019 at 2:59 pm#29052
    CLOC-AdminCLOC-Admin
    Keymaster
        bgbassman
        Hi all,
        Where to you check for level on your 35SB3 when calibrating the levelers? Just curious where the you find the most convenient spot in relation to the control panel.
        Posted: 5:00 PM – May 08, 2013
        Jpcovert1
        I use the floor inside the door. It is about mid ship and you have enough hard surface front to back and side to side for a level. It requires lots of back and forth to fine tune. But, once satisfied you are pretty well done.
        Posted: 5:29 PM – May 08, 2013
        Traveler
        We use the counter top in the kitchen area.
        Posted: 6:33 PM – May 08, 2013
        Running_Bear
        I don’t have your model, but I used a level on the kitchen counter and also referenced the bubble level I have in the fridge.
        Posted: 9:23 PM – May 08, 2013
        rvinsant
        I check my frig for level. The manufacturer recommends it be level and it is too expensive not to make sure.

        B.W.Gentry
        Owner/Admin
        2007 Carri-Lite XTRM5
        Breckenridge, TX

      • Creator
        Topic
      • You must be logged in to reply to this topic.