Roof to wall aluminum corner round

LANDING PAGE › Forums › COMMON RV COMPONENTS & ISSUES › ON the OUTSIDE › EXTERIOR WALLS & ROOF › Roof to wall aluminum corner round

General Question
  • Creator
    Topic
  • 08/06/2021 at 8:02 pm#50216
    expired-memberexpired-member
    Blocked
      • Topics - 86
      • Replies - 191
      • Total - 277

      Cameo 37 was subject to a ‘oops’ yesterday backing into barn shop.  Forgot about new ductless we put in for office.  Basically tore off some of the TPO but creased/dented the aluminum corner round for the roof to wall joint.

      Does anyone know what radius this might be and or if there is any material similar?

      I just creased it about 1-1.5″ x 6-8 feet off the corner of the ductless compressor support frame (0.25″ x 3 angle)… complete senior moment forgetting about unit on wall but I couldn’t see up 12′ anyway :( …

      Attachments:
      You must be logged in to view attached files.
    • Creator
      Topic
    • You must be logged in to reply to this topic.